|
References (to date)
Q: What is the standard size of the units?
A: 10 inches (length) x 3/4 inch (diameter)
Q: Leave in place for life or certain period of time?
A: Leave in place for life or when you move...
Q: Where installed and how?
A: We will note where to install from the "sketch/sketches"
sent in for analyses... They will be installed 3 inches from the
floor by a clamp to hold in place... There is a "RED" point
on one end to show the proper alignment for installation.
Q: Who installs them?
A: Anyone with a mechanical or handyman's ability.
Q: Shape of Mold Bars?
A: They are "round".
Q: How long do they last / Need replacement?
A: They last indefinitely and never need any replacement,
maintenance or regeneration of any sort.
Q: Does it remove / reduce Legionnaires' disease?
A: Quite possibly when/if installed in "all" the intake ducts.
From: Henry K
To: drgeorge@energy-group.com
Sent: Tuesday, April 27, 2004 9:31 AM
Subject: Letter on stabilizer bar
Dear Dr. George,
During the winter of 2001, a bad snow storm caused ice damning and then water damage in our 16 x 70
mobile home in Wisconsin. Eventually the water damage caused mold to form. Our health became
affected from inhailing the mold to the point we were considering leaving the house. Our insurance
company refused to help, so in desperation and with the suggestion of Stabilized Energy System, we
installed stabilizing energy bars in the house. We installed 9 of the 3/4 x 10 inch bars in our
home, one at each outside corner, one at each corner in our kitchen and one on the ground cable of
the electrical system . After we installed the stabilizing bars, we notised improvement of the air
in our home and we also noticed that the water felt softer to the touch and the iron deposits in
the sink were less noticeable. After several months we also installed an air purifier and to date
we are still living in our home without any ill health problems.
A Happy Customer
Hank
|
made aware of... (4B)